The Tax Timing Differences report [R0310] consists of 2 reports showing the temporary timing difference and permanent difference between tax and accounting books. Differences are caused by a difference in the classification of a lease for tax and accounting books. For example, a lease could be considered an operating lease for tax purposes and a direct finance lease for accounting purposes. Temporary timing differences eventually wash out to zero. Permanent differences arise because a portion of the asset's cost is disallowed as part of the tax basis (e.g., half of the ITC taken when ITC is retained in full by the lessor). Therefore, the tax and accounting books have different starting points (tax basis reduction vs. full cost).
The following reports are produced:
The report is organized by Portfolio, Company, Region, Office. The report may be accessed through the Controllers Tax report menu [R03] and may be selected interactively for:
The Tax Timing Differences
report [R0310A] reports at the asset level and provides the following information:
1/2
ITC
* DEPRECIATION PERCENTAGE
* PORTFOLIO TAX RATE
The Tax Timing Differences - Operating report [R0310B] reports at the asset level and provides the following information:
1/2
ITC
* DEPRECIATION
PERCENTAGE
* PORTFOLIO
TAX RATE
LeasePak Documentation Suite
©
by NetSol Technologies Inc. All rights reserved.
The information contained in this document is the property of NetSol Technologies Inc. Use of the information contained herein is restricted. Conditions of use are subject to change without notice. NetSol Technologies Inc. assumes no liability for any inaccuracy that may appear in this document; the contents of this document do not constitute a promise or warranty. The software described in this document is furnished under license and may be used or copied only in accordance with the terms of said license. Unauthorized use, alteration, or reproduction of this document without the written consent of NetSol Technologies Inc. is prohibited.
This message should disappear within 5-15 seconds, depending on the size of the document and the speed of your connection to the Documentation Suite.
If you can still see this message after 20 seconds, try clicking the Refresh or Reload button on your Web browser.
If your document still does not load, refer to Document Load Troubleshooting for instructions on how to fix possible problems with either your Documentation Suite installation or Web browser setup.
If you do not have read access to the parent docsuite directory, you will not be able to load the Document Load Troubleshooting document. In this case, contact your network administrator for assistance.